4.2.1 Access to parameter settings
To enter the sequence of modifying parameters, you must press and hold, the forward
key "*" for three seconds. After this time, the first parameter is displayed.
From this moment there are two options:
1- Modify the value of the parameter.
•
By pressing
“
” forward key, you can select values and the parameter number
correspondingly.
•
Press
“
” again to return to display the parameter number.
•
To increase the value of the parameter, press the “+” key. That increases the
value of the selected digit until it reaches the maximum value the next press goes
to the minimum value.
If the parameter entered is incompatible with the computer, that parameter
will not be accepted. For example, our equipment has a parameter code for each
protocol ("2" ISO 1745, "3" ModBus ... "10" Profinet, etc). In a DN-NN family viewer
that in this version can only work in Profinet, it will not accept any parameter other
than "10".
2- Select another parameter.
To select another parameter, you must flash the parameter name using the "
" key and
then select the new parameter using the "
+
" key. The parameter number is the third digit starting
from the right.
To exit the sequence of modifying parameters you must select the
parameter F
and then
press "
".
