background image

Larson Electronics, LLC

 

Phone: (877) 348-9680

 Fax: (903) 498-3364 

 www.larsonelectronics.com 

6

 of 

6

 

Cleaning

CRAZING/CRACKING Crazing (fine cracks) of lenses causes reduced effectiveness of the light. Do not use 

cleaning agents (which causes crazing) such as strong detergents, solvents, or petroleum products. If crazing 

of the lens es does occur, the reliability of light for emergency signaling purposes may be reduced until the 

lenses are replaced. 

CLEANING the POLYCARBONATE LENSES: To extend the life of this device, periodic cleaning is necessary. 

Clean the lens with a mild, non-abrasive, neutral-pH cleaning agent and a soft, clean cloth. Rinse the device 

thoroughly to ensure that no cleaning agent residue remains. To avoid water spots, dry the device with a soft 

clean cloth. Failure to follow this precaution can cause crazing or cracking of the lens/dome and voids the 

warranty claims for the light.

USE AND CARE

Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment. 

Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of 

children when not in use. Inspect for good working condition prior to storage and before re-use.

 

 

REPLACEMENT PARTS

The 

GL-9051-F-M

 is designed to provide years of reliable performance. Should the need for replacement parts arise, 

please contact Larson Electronics. 

THESE  INSTRUCTIONS  MAY  NOT  COVER  ALL  DETAILS  OR  VARIATIONS  OF  THIS  PRODUCT  FOR  YOUR  EQUIPMENT  OR  INSTALLATION 

REQUIREMENTS.  SHOULD  FURTHER  INFORMATION  NOT  COVERED  BY  THESE  INSTRUCTIONS  BE  REQUIRED,  PLEASE  CONTACT  LARSON 

ELECTRONICS BY EMAIL AT 

[email protected]

 OR BY PHONE AT 

1-877-348-9680

 FOR FURTHER ASSISTANCE. 

PLEASE VISIT LARSONELECTRONICS.COM FOR 

WARRANTY

 AND 

RETURN

 INFORMATION.

Figure 5  Controller

Spot in/

Spot out

Directional 

Buttons

Directional

Buttons

Power

Memory

Presets 1, 2, 3

Operation

LIGHT HAZARD:

 

This product contains a high intensity LED 

device. To prevent permanent eye damage, DO NOT stare into 

the light beam at close range.

When the search light is powered on, it will perform a calibration 

procedure. It will rotate to zero and return to the last position it was 

at when powered off.
Select a unit to be controlled from one of the three presets by 

pressing its button. If it is paired and connected, it is made the 

active connection, and the button turns solid green. If it is only 

paired, the controller scans for up to 30 seconds (the button 

flashes blue while scanning) or until it connects. (The button turns 

solid green.) If no search light has been paired for the selected 

button, the button flashes red briefly, and if the last active search 

light is still connected, it will be selected.
Power the unit on and off using the power button. 
Aim the light to the work area by using the Up-Down and Left-

Right buttons. 
Adjust the spot size by using the spot in and spot out buttons.

Once a desired position is reached, this may be programmed as a 

preset by pressing the M1 or M2 buttons for five seconds until the 

Power button blinks.  If the light is moved from this position, it may 

be returned to by pressing the selected memory button.

GL-9051-F-M

Отзывы: