![background image](http://html1.mh-extra.com/html/larson-electronics/epl-led7w/epl-led7w_instruction-manual_3731514002.webp)
EPL-LED7W
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
Wiring Instructions
Remove the wiring access plug. For high voltage fixtures, connect neutral to white fixture wire and line to black fixture wire, connect
ground (earth) to ground lug inside the fixture. For low voltage fixtures, connect low voltage (+) to white fixture wire, and low voltage (-)
to black fixture wire. Make all wiring connections accordance with accepted NEC and local wiring procedures for factory sealed fixtures.
Be sure any unused wiring entrances are closed with closure plugs provided.
Maintenance
Following this manual information will extend the lifespan and use of this light in a safe manner.
KEEP THIS LIGHT AND ALL ACCESSORIES OUT-OF-REACH OF CHILDREN.
Turn OFF the supplying circuit before opening fixture for re-lamping. To re-lamp loosen the locking screw and remove the globe support
assembly.
The globe support assembly disengages after approximately 3 turns. Access to the fixture internal lamp area is only necessary for
changing the flash pattern. Clean the threads and apply a thin coating of lubricant before reassembling.
To maintain maximum light output, the fixture should be cleaned periodically. Maintenance procedures sometimes require fixtures to be
hosed down for good housekeeping.
The supply circuit must be turned OFF and the fixture globe must be allowed to cool to the ambient room temperature before cleaning.
Only mild, non-abrasive cleaning agents should be used. These periodic cleaning procedures are important to prevent the accumulation
of dust and dirt which will impair the light output of the fixture. The glass globe should be regularly inspected for scratches and chips
and, if damaged, the entire globe support assembly must be replaced.
Caution Notice:
Technical information, advice and recommendations contained in these documents is based upon information that Larson Electronics
LLC believes to be reliable. All of the information and advice contained in these documents is intended only for use by persons having
been trained and possessing the requisite skill and know-how and to be used by such persons only at their own discretion and risk. The
nature of these instructions is informative only and does not cover all of the details, variations or combinations in which this equipment
may be used; its storage, delivery, installation, check-out, safe operation and maintenance. Since conditions of use of the product are
outside of the care, custody and control of the manufacturer, the purchaser should determine the suitability of the product for his
intended use, and assumes all risk and liability whatsoever in connection therewith.
All lights are thoroughly tested before shipping. However, should you encounter a problem during installation or during the life of
the product, refer to the guide below for information on troubleshooting. In most cases problems that occur will be related either to
the power/control wiring.
For personal safety, always confirm the rating of any known hazardous or potentially hazardous location where the light is to be
used.
Use and Care
Unauthorized modification may impair the function and/or safety of the LED light could affect the life of the equipment. Always check for
damaged or worn out parts before using the light.
Should further information not covered by these instructions be required, please contact Larson Electronics at 1-800-369-6671 or
Please visit LarsonElectronics.com for
Warranty
and
Return
information.