LT-3100S GMDSS User & Installation Manual Rev. 1.02
Lars Thrane A/S
www.thrane.eu
iii
Safety Instructions for the Operator
The following safety instructions must be observed during all phases of operation, installation, service and
repair of this equipment. Failure to comply with these precautions or with specific warnings elsewhere in
this manual violates safety standards of design, manufacture and intended use of the equipment.
Lars Thrane A/S assumes no liability for the customer's failure to comply with these requirements.
Instructions for the Operator
WARNING
–
Do not disassemble
Do not disassemble or modify this equipment. Fire,
electrical shock, or serious injury can result.
WARNING
–
Keep away from live circuits
Operational personnel must not remove product
enclosure. Do not service the equipment with the
communication cable connected. Always
disconnect and discharge unit, cable and circuits
before touching them.
WARNING - Permanent watch
In case of smoke or water leaks into the
equipment, immediately turn off the power.
Continued use of the equipment can cause fire or
electrical shock. Keep access and permanent watch
of the equipment in order to prevent any
unwanted escalation.
WARNING
–
DC mains connector
The DC mains connector is to be used as the
disconnection device to isolate the equipment
from the mains supply.
IMPORTANT - Safety distance
The safety distance from the LT-3130 Antenna
Unit, when the LT-3130 Antenna Unit is powered
and transmitting, is 0.1 m (0.3 ft), in order to
comply with the regional regulations.
Always keep this safety distance to the LT-3130
Antenna Unit to avoid any serious injury.
If the safety precautions and warnings on this site are not followed, warranty will be void.
Содержание iridium LT-3100S
Страница 2: ......
Страница 83: ...Lars Thrane A S Skovlytoften 33 2840 Holte Denmark www thrane eu...