Lars Thrane iridium LT-3100S, Руководство пользователя и инструкция по установке

Страница: 4 / 83

LT-3100S GMDSS User & Installation Manual Rev. 1.02
Lars Thrane A/S www.thrane.eu ii
WARNING - Product installation
To ensure correct performance of this equipment,
it is strongly recommended that professionals with
expertise, properly trained, and likewise authorized
within the industry is completing the installation.
WARNING – DC circuit breaker
DC circuit breaker must be used as ON/OFF switch
on the Control Unit and Interface Unit.
WARNING – Overcurrent protective
Overcurrent protective devices used as safeguard
(specific to IEC 62368-1) - Lars Thrane A/S has the
responsibility of use of non-IEC approved fuses in
the equipment.
Safety Instructions for the Installer
The following safety instructions must be observed during all phases of operation, installation, service and
repair of this equipment. Failure to comply with these precautions or with specific warnings elsewhere in
this manual violates safety standards of design, manufacture and intended use of the equipment.
Lars Thrane A/S assumes no liability for the customer's failure to comply with these requirements.
Instructions for the Installer
WARNING – Turn off power switch
Turn off the main power switch before installing
the equipment described in this manual. Do not
connect or disconnect equipment when the main
power switch is on.
WARNING – Input Power
The input voltage range is: 12-24 VDC.
WARNING – Power supply protection
Make sure that the power supply is adequately
protected by a fuse or an automatic circuit breaker
when installing the equipment:
LT-3110S Control Unit (max. 15.0 A)
LT-3140S Interface Unit (max. 5.0 A)
WARNING - Explosive atmosphere
Do not operate the equipment in the presence of
flammable gases or fumes. Operation of any
electrical equipment in such an environment
constitutes a definite hazard.
WARNING - Compass safe distance
The compass safe distance for standard and
steering compasses is 0.85 m (2.8 ft) and 0.65 m
(2.1 ft) respectively. Observe these distances to
prevent interference to a magnetic compass.
If the safety precautions and warnings on this site are not followed, warranty will be void.