Ediz. 010 - 06/2015
CORRECT POSITIONING OF THE PUMP UNIT
Once the unit has been refitted, proceed as follows:
• Check the position of the rod, which should be positioned
at its lower stopping point.
• Put the pump unit (
P10
) inside the reduction cover (
P33
)
as shown.
• Screw the pump unit (
P10
) inside the reduction cover.
The reference value
(see drawing)
must be 18 mm.
The maximum tolerance accepted for correct ope-
ration is 21 mm maximum and 16 mm minimum.
• Use a gauge to measure the gap between the base of the
template and the tightening groove.
• Screw the pump unit onto the front template, making sure
that the end of the stem is aligned with the rod groove
(
P34
).
• Align the two holes
(rod + stem)
and insert the stopping
pin (
P35
) inside the rod (
P34
).
• Check that the closing spring (
P36
) in the rod (
P34
) is
aligned with the pin housing when closed (
as shown)
.
www.larius.eu
JOLLY
28
18mm
Refer
ence
min. 16mm
max. 21mm
P36
P35
P34
P10
18 mm
P10
P33