Lanzar VBD1900MP, Руководство пользователя

Страница: 9 / 20

9
OPERATION
• SWITHCHING ON/OFF THE UNIT
Switch on the unit by pressing right-
top button (1) on the back of the front
panel shortly and some information will
be shown on the display (2). Then you
can press and hold the button (1) for
several seconds to turn off the unit.
When the unit is on, press the button
(1) shortly, the front panel will turn
upside down from State 1 to State 2
to State 3.
When the panel is in state 3, press and
hold the
(CLOSE) button (9) on the
front panel to turn off the unit. Then
you can press
(CLOSE) button (9)
shortly to turn on the unit again. When
the unit is on, press the
(CLOSE)
button (9) shortly, the front panel will
slide down and turn upside from State
3 to State 2 to State 1 (the initial state).
• SOUND ADJUSTMENT
Press SEL button (10) shortly to select
the desired adjustment mode.
The adjustment mode will change in
the following order:
By pressing the + button (11) or -
button (12), it is possible to adjust the
desired sound quality.
Press and hold the SEL button (10)
for several seconds to enter into the
selection for the situation of beep
sound, then press the + button (11) or
- button (12) to select as follows:
- BEEP 2ND mode:
The beep is only generated when all
allowed double function button is
pressed long (several seconds).
e.g.
When preset button is pressed.
When
BND/LOU button (13) is
pressed.
When
AMS button (18) is pressed.
- BEEP ALL mode:
The beep is generated when every
button is pressed.
- BEEP OFF mode:
The beep is disabled.
• LOUDNESS
Press BND/LOU button (13) for
several seconds to reinforce the bass
output. Press it for several seconds
again to release this function.
• SET THE CLOCK
Press the DSP button (15), the clock
is shown on the LCD display. Then hold
down the button until the clock flashes.
Then press the
TUNE/TRACK
button (16) to change hours or
TUNE/TRACK button (17) to change
minutes.
• MUTE
Press MUT button (7) to mute down
the sound instantly. If any button is
pressed in the mute state, the mute
mode is released. When PTY or TA is
received, the mute mode is also
released.
• EQUALIZATION
Press EQ button (25) to turn on
equalization function and to select
desired audio mode. There are five
kinds of mode as below:
• SUBWOOFER
Press MODE button (6) for
several seconds to toggle subwoofer
output.
Press it for several seconds again to
release this mode.
• LIQUID CRYSTAL DISPLAY
Exhibit current frequency and
activated functions on the display (8) or (2).
• REMOTE SENSOR
When the front panel is in State 1,
point the remote control handset to
the remote sensor (31) and when the
panel is in State 2 or State 3, point the
remote control handset to the remote
VOL BAS TRE BAL FAD
(Volume) (Bass) (Treble) (Balance) (Fader)
BEEP 2ND BEEP ALL BEEP OFF
FLAT CLASSICS POP M ROCK M DSP OFF