5
5
:
:
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
This chapter covers all of the steps needed to get the SCS online and working.
EZWebCon is the preferred method for initial configuration, but this chapter also explains
alternative methods such as the command line interface. The full command set is
discussed in the
SCS Reference Manual
.
Before you begin,
note the following points:
1.
The IP address must be configured before any TCP/IP functionality is available. You
cannot use the web browser interface until an IP address is assigned.
2.
Most configuration commands require privileged user status. You must enter the
Set
Privileged
command to become the privileged user. The default privileged password
is
system
.
Connecting
the
SCS
1.
Place the SCS in a secure location close to the device or devices it will service.
2.
Connect your serial devices to the DB25 and/or DB9 serial connectors as appropriate
for the SCS model.
3.
Connect the Ethernet network to the SCS in one of the following ways:
Connect to the 10/100BASE-T port.
Note
:
You must use a 10/100BASE-T wired connection if you
wish to perform initial configuration over the network.
For the SCS200 and SCS400, if desired, insert a supported modem
card, ATA card, or 802.11 card in the PC card slot.
4.
Connect the power supply to the SCS. See the appropriate SCS Components
chapter for power connection specifications.
5-1