Lantronix
TN-USB3-xx-01Series User Guide
33644 Rev. F
Page
24
of
27
Compliance Information
Declaration of Conformity
Manufacture’s Name: Lantronics, Inc.
Manufacture’s Address: 48 Discovery, Suite 250, Irvine, California 92618 USA
Declares that the product(s): TN-USB3-SX-01(SC), TN-USB3-SX-01(LC), TN-USB3-SFP-01
Conforms to the following Product Regulations:
Electromagnetic Compatibility (EMC) Directive 2014/30/EU; FCC Part 15 Class A
Directive 2014/30/EU, Directive 2015/863/EU
With the technical construction on file at the above address, this product carries the CE Mark
I, the undersigned, hereby declare that the equipment specified above conforms to the above Directive(s) and
Standard(s).
Place: Irvine, California
Date: July 14, 2023
Signature:
Eric Bass
Full Name: Eric Bass
Position: Vice President of Engineering
FCC Regulations
RADIO AND TELEVISION INTERFERENCE
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the
FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or
relocate the receiving antenna.
- Increase the separation between the equipment
and the receiver.
- Connect the equipment into an outlet on a circuit different from that to w
hich the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes and Modifications not expressly approved by the manufacturer or registrant of this equipment can void your
authority to operate this equipment under Federal Co
mmunications Commission’s rules.
*
In order to maintain compliance with FCC regulations shielded cables must be used with this equipment. Operation with
non-approved equipment or unshielded cables is likely to result in interference to radio & television reception.
* NOTE
: Shielded cables were used when testing this product.
