Lantronix C3210-10 Series, Руководство по установке

Страница: 5 / 20

Lantronix C3210 Install Guide
33414 Rev. D https://www.lantronix.com/ Page 5 of 20
Installation
CAUTION : Wear a grounding device and observe electrostatic discharge precautions when handling the
SIC media converter. Failure to observe this caution could result in damage or failure of the SIC.
DIP switches
The C3210 has two DIP switches mounted on the PC board:
a 6-position DIP (first set at left) and on some units, a 4-position DIP
(second set to the right). If your unit has a second set of DIP switches,
note that they are not used at this time.
6-position DIP switch
The 6-position DIP switch is located on the circuit board of the C3210 media converter. Use a small, flat-
blade screwdriver (or a similar tool) to set the switches according to the site requirements (see the
drawing below).
Note 1 : Only use when Auto-Negotiation is disabled.
1. Twisted-Pair Auto-Negotiation
UP Enable Auto-Negotiation for the copper connection.
DOWN Disable Auto-Negotiation for the copper connection.
2. Twisted-Pair 10Mbs/100Mbs (See Note 1)
UP Set copper connection speed to 100Mbs.
DOWN Set copper connection speed to 10Mbs.
3. Twisted-Pair Full/Half Duplex (See Note 1)
UP Operate in full-duplex mode.
DOWN Operate in half-duplex mode of the attached device.
4. Link Pass-Through (LPT)
UP Enable Link Pass-Through
DOWN Disable Link Pass-Through.
5. Fiber Full/Half Duplex
UP Operate in full-duplex mode.
DOWN Operate in half-duplex mode of the attached device (valid for 100FX models only).
6. Not used