Lantronix
C3210 Install Guide
33414 Rev. D
Page 12 of 20
SNMP
See the on-line documentation that comes with the FocalPoint software for applicable commands and
usage.
Use SNMP at the attached terminal or at a remote location to monitor the C3210 by monitoring:
•
Copper and fiber link status
•
Copper and fiber port duplex
•
Copper port speed
Use SNMP to enter network commands that:
Card Level:
•
Assign Circuit ID information
•
Set Link Pass Through
•
Set Switch Forwarding Aging Time
•
System Reset
Port 1:
•
Assign Circuit ID information
•
Port Configuration
•
Auto Negotiation Settings and Advertised Capabilities
•
Port Forward Management
•
Virtual Cable Test
•
Bandwidth Allocation
•
MAC Security
•
VLAN Forwarding Rules
•
Priority Forwarding Rules
•
VLAN Tag Management
•
User Priority
•
RMON Counters
•
Port Counters Received
•
Port Counters Sent
•
Dot3 Statistics
Port 2 (Same as Port 1 plus the following):
•
DMI Statistics
RMON counter on each port
RMON statistics such as packet size counters, collision errors, and packet type are kept for each port.
Switch selectable speed
On UTP (unshielded twisted pair) when Auto-Negotiation is disabled the speed can be sent in either
software or hardware mode.
Virtual cable test (VCT) on UTP port
The VCT feature utilizes Time Domain Reflectometry (TDR) technology to remotely and non-evasively
diagnose the quality and characteristics of the attached cable plant. Using this technology, the devices
detect and report potential cabling issues such as cable opens, cable shorts or any impedance mismatch
in the cable and accurately report (within one meter) the distance of the fault. In addition, VCT technology
will detect pair swaps, pair polarity reversal, and an excessive pair skew.
