Lantronix
ION x222x / x32xx Install Guide
33433 Rev. D
Page
27
of
42
Initial Setup with a Static IP Address via the CLI
The x222x/x32xx supports IPv4-based application protocols. The x222x/x32xx can be assigned IP
address statically or dynamically using DHCP. The x222x/x32xx supports DNS, which lets you assign it a
hostname instead of an IP address. The static IP address assignment is part of the initial x222x/x32xx
setup, and at first the CLI (command line interface) is used to configure the IP address settings.
Thereafter, remote management and/or DHCP addressing can be configured.
The default values are IP Address = 192.168.0.10, Subnet Mask = 255.255.255.0, Default Gateway =
192.168.0.1, with no DNS address assigned, and no DHCP client enabled. When manually setting the
x222x / x32xx NID’s IP address, it can only be given a Class A, Class B or Class C address; it can not be
given a multicast or reserved IP address. The multicast addresses, loopback addresses, and link local
addresses that can be used in a local network include 10.0.0.0~10.255.255.255,
172.16.0.0~172.31.255.255, and 192.168.0.0~192.168.255.255).
The following procedure is for setting a static IP address for the x222x/x32xx NID. When this procedure is
completed, you can communicate with the x222x/x32xx across the network via either a Telnet session or
the Web interface.
1. Start a USB session (see “
Starting a USB Session
” on page
27
).
2. At the command prompt type
set ip type=ipv4 addr
=<xx>
subnet–mask
=<yy> where:
xx = IP address of the NID
yy = subnet mask
3. Press
Enter
.
4. Set the IP address mode. Type
set ip address mode
=<xx> where:
xx = the IP addressing mode (bootp, dhcp, or static).
5. Type
set gateway type
=
ipv4 addr
=<xx> where:
xx = default gateway address (note that only one default gateway can be set)
6. Press
Enter
.
7.
Verify the setup. Type
show ip-mgmt config
and press
Enter
. The current configuration displays.
For example:
Agent III C1|S9|L1D>
set ip type
=ipv4
addr
=192.168.1.10
subnet–mask
=255.255.255.0
Agent III C1|S9|L1D>
set ip address mode
=static
Agent III C1|S9|L1D>s
et gateway type
=ipv4 addr=192.168.0.1
Agent III C1|S9|L1D>
show ip-mgmt config
IPv4 management configuration:
------------------------------------------------------------------------
IP management state: enable
IP address: 192.168.1.10
IP subnet mask: 255.255.255.0
Gateway IP address: 192.168.0.1
IP address mode : Static
