INSTALLATION AUXILIARY FIGURES
Accessories
Mount ear
Mount rack
Pulling cable x 1
Power cord x 1
Slider set x 16
Mount ear x 2
Rubber pedestal x 4
Take screws off to remove mount ear
Fasten screws in rack to fix the Chassis
Upper and lower slider of
media converter
Slide in
Slide out with pulling
cable
1
2
When installing the media converter to the Chassis,
please attach two sliders to the media converter first.
1. Take off 4 screws from the media converter.
2. Fasten two sliders with screws in top and
bottom locations.
Push the media converter into the Chassis and
fasten screws on the slider of media converter.
Pull out the media converter with the pulling
cable.
Note:
1. For recent media converters, there are 4 reserved screw holes on
laterals or sliders.
2. If your media converters are older versions, please unscrew
first (Refer to Point 1).
3. If your media converters already have reserved lateral holes, please
fasten the sliders directly (Refer to Point 2).
Top view with fan location
Fan replacement
Power replacement
A C 1 0 0 - 2 4 0 V
A C 1 0 0 - 2 4 0 V
AC 1 00 -2 4 0 V
1
AC 1 00 -2 4 0 V
2
Unfasten four screws for fan replacement.
1.Take the fan out from the Chassis, then
pull power jacket off.
2. Replace a new fan, then put power jacket back.
3. Push the new fan back to the Chassis.
4. Fasten four screws.
Remove screws from two sides of power
supply then pull power supply out.
