15
Hardware Installation
In this paragraph, it will describe how to install the 8 10/100TX with redundant
ring Web management industrial switch and the installation points for attention.
1. Unpack the Industrial switch.
2. Check the DIN-Rail is screwed on the Industrial switch. If the DIN-Rail is not
screwed on the Industrial switch. Please refer to
DIN-Rail Mounting
section
for DIN-Rail installation. To wall mount the Industrial switch, please refer to
Wall Mount Plate Mounting
section for wall mount plate installation.
3. To hang the Industrial switch on the DIN-Rail track or wall, please refer to
the
Mounting Installation
section.
4. Power on the Industrial switch. How to wire the power; please refer to the
Wiring the Power Inputs
section. The power LED on the Industrial switch
will light up. Please refer to the
LED Indicators
section for meaning of LED
lights.
5. Prepare the twisted-pair, straight through Category-5 cable for Ethernet
connection.
6. Insert one side of Category-5 cables into the Industrial switch Ethernet port
(RJ-45 port) and another side of Category-5 cables to the network devices’
Ethernet port (RJ-45 port), ex: switch, PC or Server. The UTP port (RJ-45)
LED on the Industrial switch will light up when the cable connected with the
network device. Please refer to the
LED Indicators
section for LED light
meaning.
[NOTE]
Be sure the connected network devices support MDI/MDI-X. If it
does not support then use the crossover category-5 cable.
7. When all connections are all set and LED lights all show in normal, the
installation is complete.
