www.lanpro.com
Active Products - Switches - LP-SGW2400
Chapter 2 Hardware Installation
B
2.1 Quick Installation Guide
Choose a proper place for the LP-SGW2400 rack mountable switch, considering the surroundings such as power
requirements, space, keep it away from sunlight, heat source, and electromagnetic interference area. The wind range
must be at least 10 cm (3 inches) for a good ventilation.
Stick the rubber padding to the rear side of the switch.
Use standard EIA 19’ rack mount and fix the rack on both sides of the switch.
LanPro has a complete line-up of cabinets, racks and Server racks for all kinds of applications.
Adjust the holes so that they can fit and fasten the switch with the turnbuckle.
Plug the cable into the switch socket, turn the power on, the switch will test itself, all indicators
and lights are on at the same time, after 5 seconds the lights automatically turn off and test is
done.
Put one end of the Cat.5, Cat5e or 6 cable cable into a RJ45 port of the switch, the other end is
connected with the NIC card and router If the power of the switch is on, the related indicators
are on. Every port of the switch can be used as Uplink port.
Note:
Don’t plug a phone line into an RJ45 port, otherwise it will damage the unit.
The switch can adjust the power automatically depending on the input voltage range within the
marked voltage on the rear board.
Installation & Connection method:
2.2 LED Indications
LED
Status
Indications
Power
ON/OFF
Power on/off
Link/Act
ON/OFF
Ports connected/Ports unconnected
FLASH
Data frames are through
Speed
ON/OFF
The transmission rate among ports is 1000Mbps./
The transmission rate is 10/100 Mbps.
Chapter 3 Configuration Guide
C
3.1 Fast Log In
Notice:
You must configure IP for the managing PC, because the default parameter of the switch is listed
as below: Default IP address is 192.168.2.1, there is no password. You can log in the switch setting
window through the steps as below:
1
2
3
4
5
6
Connect the switch with the managing PC adapter.
1
Turn on the switch power supplier.
2
Make sure the PC IP address belong to 192.168.2.xxx,
e.g:192.168.2.100(xxx is the integer between 2~254).
3
3
