www.lanpro.com
Active Products - Switches - LP-SGW2400
12
6.1 Com Port Set-up
To use the command line interface you may connect a PC
COM port to the RS-232 connector and activate a terminal
program, e.g. HyperTerminal under Windows. The COM port
must be set up to run 8 data bits, 1 stop bit, no parity,
115200 baud and without flow control.
Figure 27
Chapter 6 Command Line Interface
F
6.2 Command Hierarchy
The CLI is hierarchical with two levels: a top level and a group level. The group level consists of the following groups:
System, Console, Port, MAC, VLAN, Aggregation, LACP, RSTP, User Group, QoS, Mirror, IP, Dot1X, Debug.
At top level you may enter a command by giving the full command string, including group, or you may change context into
a group by entering the name of the group.
At group level you may enter commands for the particular group you have chosen without specifying the group name or
you may return to the top level by entering the up command.
The current level and group is indicated by the prompt. If you are at the top level, the prompt will be:
>
If you are at group level, the prompt will display the actual group, e.g.
System>
At group level you also have the option of using the slash
(/)
key to refer to a context relative to the top level. E.g.
you may be in the system group and enter a /console/configuration command or change context into the console group by
entering
/console
.
Figure 28
