Chapter 3:
Hardware Setup
Preparing the Hardware Installation
To access some components and perform certain service
procedures, you must perform the following procedures
first.
WARNING:
To reduce the risk of personal
injury, electric shock, or damage to the
equipment, remove the power cord to
remove power from the server. The front
panel Power On/Standby button does not
completely shut off system power. Portions of
the power supply and some internal circuitry
remain active until AC power is removed.
Unpower the FW-7525 and remove the power cord.
1.
Unscrew 3 screws on each side and on the bottom of
2.
the cover of the FW-7525 System.
Slide the cover backwards to open it.
3.
Installing the System Memory
The motherboard supports DDR3 memory that features
data transfer rates of 1333, 1600 MHz to meet the higher
bandwidth requirement of the latest operating system
and Internet applications. To install the memory:
Aligh the SO-DIMM’s key with the socket’s notch.
1.
Install the memory.
2.
Note:
The system requires
1.
Non-ECC DDR3 1333/1600
MHz
memory
.
Do not install memories with
different specifications.
The system can support up to 8 GB in maximum.
2.
Installing Disk Drive
The system can accommodate one 2.5” SATA SSD disk
drive. Please follow the steps below for installation.
1. Install three standoffs (brass joints) as shown in the
image below.
2. Prepare the SSD bracket.
