Lanier LW110, Руководство по эксплуатации

Страница: 44 / 189

Copy Settings
32
3
Partial Copying
The Partial Copy function copies only a part of an original.
You need to enter start and end points in the feed direction of the original .
Note
❒
You cannot use the Partial Copying function when using the Rear Table.
❒
You cannot use the Partial Copying function for originals shorter than
150mm.
❒
You can use the Partial Copying function for originals longer than 1270mm.
❒
If you set the start point within 130 mm of the leading edge of the original, the
copier will regard the leading edge as the start point.
❒
The minimum available space between the start point and the end point is 30
mm.
❒
If you do not set the end point after setting the start point (a), the copier will
regard the trailing edge of the original as the end point (b).
❒
If you do not set the end point in the Semi Synchro Cutting function, the pa-
per extend by 200mm from the end point (from c to d). The paper extend by
310mm from the trailing edge.
A
Hold down the
{{{{
Function Select
}}}}
key for three seconds or more.
A "P" will blink in the copy counter display.