Lanier R/C
Stinger .60 ARF
Using the 2mm x 20mm bolts and nuts, bolt
the two long flying wires to the fin in the
pre drilled holes.
Insert the bolts through the tab on the
other end of the wire and insert into the
stab. Turn the plane over and attach the
short flying wire to the bolt on the
bottom side of the stab. Attach the clevis
on the other end of the short flying wire
to the aluminum bracket. Adjust the
tension on the flying wires by removing
the clevis on one end and turning. Be
careful not to warp, bow, or twist the
stab and fin when adjusting the tension.
When adjustments are correct tighten the
lock nuts in place.
Hatch Mounting
Remove the covering from the screw
holes on the rear of the wing and install
the 4mmx20mm bolts.
Bolt the wing in place and fit the hatch
into the dowel holes in F2. Take a
marking pen and mark along the sides of
the hatch from 2 to 3 inches in front of
the trailing edge.
Remove the hatch and measure over
3/16" from the mark you made and make
another line. Locate the 3/8"x 11/16"x 1"
hardwood blocks and position them on
the inside mark at the front edge of the
bolt reinforcement plate.
Mark around the block then remove the
covering where they will glue down. Use
epoxy and glue in place. Use a small
piece of tri stock(3/8"x1") on the back
side to reinforce the part. Remove the
covering under it and epoxy in place.
Mark the location of the block on the
hatch cover.
Lanier R/C INC. P.O. Box 458 Oakwood, GA. 30566
Phone 770 532 6401 FAX. 770 532 2163
10
