©
langer audio
6
7. The signal cables of the tonearm can be routed through a big hole in the
bottom plate of the turntable (refer picture). Usually, there is a ground cable
installed at the tonearm. It must be connected to the turntable chassis ground,
to avoid hum noise. There is a connection point for this cable at the chassis
bottom plate (refer picture).
8. Normally, there is also a ground connection needed between amplifier and
turntable. This is to avoid hum noise. Therefore, use cable (E) and connect it
to the ground point at the backside of the turntable (refer picture below). The
other end of the cable must be connected to the amplifier’s ground clamp.
9. For cartridge installation, please refer the manual of your tonearm
manufacturer.
10. Now you can connect your turntable to mains. Please use the power cable (F)
and connect it with the plug at the backside of your turntable (refer picture
below).
Attention!
Do only use a power cable in perfect
condition, to prevent electric shock
or fire hazard.
