16 / 26
3.4.10 Mounting shaft door actuator
The old shaft door actuator is replaced with a new electric shaft door actuator.
-
Dismantle the old shaft door actuator.
-
Dismantle old lever.
-
Clean and fit to handle the new shaft door actuator.
-
Drill holes for the safety contact bridge.
-
Install the new shaft door actuator at the panel.
-
Connect contact safety circuit.
-
Connect Sinus drive with the TSG electronic.
NOTE:
The levers are taken from the original shaft door actuator!
Abb. 9: new electrical shaft door actuator
