Installing the cable
1.
Unclip the wire bundle and
stretch out the wire. The
cable is 43 feet in total. 23
feet for the
left
side of the
drum (the strap side) and
20
feet for the
right
side of
the
drum (the hook side)
2.
Mark the cable at the 23
foot line with a marker or
piece of tape. Center your
mark in one of the
holes
and lace one of each
side of
the cable through
one of the
other
two holes. You
should
finish with the
longer cable
on the
left
side of the spool.
3.
Loop both wire ends
through the double pulley
in
the corner of the ceiling.
Take care that the cables
don’t cross and that the
long
side stays on the
left
pulley
and the shorter side
stays
right
.
4.
Pull the
right
side cable ( the
shorter cable) through the
middle single pulley in the
ceiling. This line will be for
the rear of the lifting frame.
5.
Pull the right side cable (the
longer cable) through the
front pulley (this should be
the pulley that was
installed
½ inch left of
center) This
cable will
attach to the front
of the
lifting frame.
6.
Attach the cables to the
front and rear using the
wire
thimbles and clamps.
Use
the farthest back hole
for
the second lifting point.
Call toll free 1866 284 7428
langeoriginals.com copyright
lange originals 2017
