Lang ECCO-AP, Руководство по обслуживанию

Страница: 29 / 73

28
TYPICAL OPERATION
ECCO-C STATUS DISPLAY
The Status Display informs the operator of the oven's status.
It can be used as a countdown timer, shelf in use or internal oven temperature display during the
cooking cycle (see ECCO-C Programming Codes pg. 16).
The Display informs the operator when the oven is ready to bake, or if the oven is above or below the
programmed temperature.
Below is a list of displays and their definitions:
"
ENTER
" The oven is energized and ready for an operator command.
"
PrEht PrEht PrEht PrEht
" Stands for “PREHEAT” . A product has been selected and the oven is
heating to the programmed temperature.
"
rEAdY rEAdY rEAdY rEAdY
” A product has been selected and the oven has preheated to the
programmed temperature. The oven is ready to load a product.
"
COOL
COOL COOL
COOL
" The oven's internal temperature is below what is programmed.
"
Hot Hot Hot Hot
" The oven's internal temperature is above what is programmed.
"
ShELF ShELF ShELF ShELF
" A product selection has been made after the oven has preheated and the
computer is asking which shelf the product is placed on.
"
hELP hELP hELP hELP
" There is a fault in the control system, the computer will not operate until
service is performed.
"
Cont
Cont Cont
Cont
" Stands for “CONTINUOUS” . The oven has been programmed without a
time being entered. The oven will operate continuously at the
programmed temperature.
"
ErrOr
ErrOr ErrOr
ErrOr
" An entry has been made during the programming, which the computer
does not understand.
ECCO-AP TYPICAL OPERATION SEQUENCE
ACTION RESULT
Turn power switch to ON. Control panel heat call light comes on.
Adjust proper temperature, between 140 & 450
degrees and allow to preheat up to 20 minutes. Oven begins heating.
Open oven doors and insert product, set timer up to
60 minutes. Timer begins counting down.
Timer beeps continuously when done. Product should now be done.