Lang ECCO-AP, Руководство по обслуживанию

Страница: 18 / 73

17
PROGRAMMING ECCO-C CONT’D
ECCO-C PROGRAMMING CODES
Below are codes, which will allow you to configure the display or aid in the operation, and
troubleshooting of the oven.
The readout must display
"ENTER" before the computer will accept any programming code. If the
readout displays any other word, reset the computer by pressing and holding the “R/C” button until
display reads “88888” then release. Display should now read “ENTER” .
The control allows for a 3-second delay between each button push, if a delay of longer than 3 seconds
has occurred, the programming code must be re-entered.
The instructions call for pressing exactly what is shown under "PRESS".
CODE DESCRIPTION PRESS
•
OPERATIONAL
Recall time remaining on a shelf Shelf
Cancel a shelf timer R/C, R/C, Shelf
•
DISPLAY MODES
Countdown timer display R/C,4,8,4,8,4,8
Shelf in use display R/C,0,9,0,9,0,9
Internal oven temperature display R/C,8,7,8,7,8,7
•
PROGRAMMING
Enter programming mode R/C,1,6,2,7,3,8
Recall an existing product program R/C, R/C, P (Product programmed)
Erase a product program R/C,1,6,2,7,3,8 (P) (000)
Model identification R/C, D,C,D,C,D,C
Fan Setting ( HI or Both) R/C,E,D,C,B,A,1(high),2 (both)
Program download (Contact Factory) R/C, A, B, C, D, E, P
•
MAINTENANCE
Actual oven temperature
Return to ENTER
R/C,3,4,5,6,7,8
R/C
•
SHELF COMPENSATION
Enter shelf compensation mode R/C, C, B, C, B, C, B
Set shelf compensations (I.E.) A,2,3,A
Return to ENTER R/C