9
INSTALLATION CONT’D
COUNTER TOP
Split the back into two pieces.
Remove the screws from the rear of the cheese-melter; screw the stainless steel portion
of the back to the cheese-melter with the offset at the top.
Reinstall the two back halves together and replace the screws around the edge.
When installing on a counter the legs must be installed before using the unit, as they
will provide the required clearance for the bottom of the unit.
Place the unit in location, and level using leg adjustments.
Observe minimum clearances at all times.
ELECTRICAL
Electrical service routing may be made through either of two 1 1/4-inch knockouts
provided. One may be found along the bottom edge of the back panel. The second
knockout is located on the bottom of the unit.
Reference the Data Plate on the left side of the unit for amperage, voltage and phase
requirements. Insure that the power supply is sufficient to meet the units power needs.
Check your local or national electrical code for fuse or circuit breaker requirements.
PHASING
All model numbers 124CM and 136CM are shipped single phase.
148CM is shipped three-phase and can be converted to single phase by moving wire #3
to L1.
ELEMENT REPLACEMENT
CAUTION: ALWAYS KEEP THE AREA NEAR THE APPLIANCE
FREE FROM COMBUSTIBLE MATERIALS.
NOTICE:
The electric cheese melter must be installed more
than 12 inches above any cooking surface and never
above any open burners or charbroilers.
1.
Disconnect from power and remove shelf.
2.
Remove three screws from each heater bracket.
3.
Remove brackets.
4.
Install the rear quartz heater (white end caps) to
the power leads on both rear sides of the unit
using the ceramic wire nuts provided.
5.
The middle and front quartz heaters (red or
brown end caps) are wired together (in series)
using the ceramic wire nuts provided.
6.
The middle and front quartz heaters are each
connected to a power lead using the ceramic wire
nuts provided. On 124 and 136 units, this connec-
tion will be on the left. On 148 units, these
connections will be on the left for the left set of
elements, and on the right for the right set of
elements.
7.
Replace brackets removed in step 3.
8.
Replace shelf removed in step 1.
9.
Reconnect to power. Turn power on and check for
proper operation
SK3182 REV - (07-23)
