Lang 124cm, Установка, эксплуатация и обслуживание

Страница: 9 / 24

9
INSTALLATION CONT’D
COUNTER TOP
Split the back into two pieces.
Remove the screws from the rear of the cheese-melter; screw the stainless steel portion
of the back to the cheese-melter with the offset at the top.
Reinstall the two back halves together and replace the screws around the edge.
When installing on a counter the legs must be installed before using the unit, as they
will provide the required clearance for the bottom of the unit.
Place the unit in location, and level using leg adjustments.
Observe minimum clearances at all times.
ELECTRICAL
Electrical service routing may be made through either of two 1 1/4-inch knockouts
provided. One may be found along the bottom edge of the back panel. The second
knockout is located on the bottom of the unit.
Reference the Data Plate on the left side of the unit for amperage, voltage and phase
requirements. Insure that the power supply is sufficient to meet the units power needs.
Check your local or national electrical code for fuse or circuit breaker requirements.
PHASING
All model numbers 124CM and 136CM are shipped single phase.
148CM is shipped three-phase and can be converted to single phase by moving wire #3
to L1.
ELEMENT INSTALLATION
Elements for all Lang electric Cheese-melters are shipped, packaged separately, within
the equipment-shipping crate.
These should be inspected upon opening of the shipping carton. If an element is found
damaged or broken, notify the Freight Company immediately.
Installation of the elements is not warrantable expense. The installer or a qualified
service company should complete installation. Damage to elements or equipment
resulting from incorrect or improper installation will be the responsibility of the
equipment owner or individual installing elements.
Elements installed in new equipment are warranted free of defects in material and
workmanship, for a period of 90 days from installation of the equipment. Replacement
elements are warranted for a period of 90 days from installation.
Remove three (3) screws from each element bracket. Brackets support each end of the
elements. One or both brackets may be removed.
Place element with red or brown ceramic ends in the front and middle position and
attach with a ceramic wire nut. (For element wiring see figures 1 and 2 on page 10).
Place element with white ceramic ends in the rear position.
Re-attach element bracket.