(850) 610-2870
www.lanesharkusa.com
42
Lane Shark LS-3
REFERENCE MATERIAL
FREQUENTLY ASKED QUESTIONS
Where can I
fi
nd my serial number?
Your Lane Shark will come with three serial number stickers.
Your serial number should read “LS2-XXXX”. The serial number
stickers can be found in the following locations: 1) On the
front face of the backplate in the upper right corner; 2) On
the spindle housing; 3) In front of the motor on top of the
deck.
At what RPM should I run my tractor while operating the
Lane Shark?
The tractor needs to be ran at minimum 540 PTO speed as
designated on the tractor’s tachometer. For heavier use, we
recommend full throttle.
Will I lose loader function while operating the Lane Shark?
You will not lose loader function if the Lane Shark is plumbed
following our speci
fi
cations.
How do I change the position of the Lane Shark?
Please refer to the Adjustment section of this Owner’s Manual
starting on page 29.
What is the cutting capacity of the Lane Shark?
The Lane Shark is capable of cutting up to 3 inch saplings,
underbrush, or limbs.
Why will the Lane Shark not start or the blades not spin?
ALWAYS disconnect the hydraulic lines from the Lane Shark before
any service or inspection is performed. Check the blade carrier and
blades under the deck for any obstructions or any material wrapped
around the rotating assembly and remove if discovered. Make sure
the hydraulic quick connect couplers are clean and seated properly.
Check all fasteners that they are secured properly, especially
those associated with the rotating assembly. Check your tractor’s
hydraulic
fl
uid level and add the appropriate
fl
uid if low. If the Lane
Shark still fails to operate properly please call your local Lane Shark
dealer or Lane Shark USA directly.
