(850) 610-2870
www.lanesharkusa.com
33
Lane Shark LS-3
ADJUSTMENTS
If you need further assistance or would like a more detailed visual reference please
refer to the QR code on pg. 31.
Vertical Position
This position allows the Lane Shark to extend from directly in front of the
tractor to horizontally beside the tractor. The o
ff
set position is the recommended
position for cutting around ponds, near ditches, and along roadsides. On this page
you will be shown how to correctly move the Lane Shark from the home position
(Shown on pg. 30) to the o
ff
set position.
Instructions
CAUTION
While changing positions on the Lane Shark there is a crushing hazard. DO NOT
place
fi
ngers, hands, or body between the Lane Shark and tractor while changing
positions.
1. Make sure all hydraulic hoses are disconnected from the Lane Shark.
2. Lift the boom of the tractor until the Lane Shark has enough clearance
between the ground to point directly down. (Shown in Figure 1)
STOP
before going any further make sure you have read and completed the
“Before you get started” section on page 29.
3.
Pull both pins on the left and right sides of the Lane Shark.
4.
Facing the front of the tractor pull the right side of the Lane Shark away from
the front of the tractor until the bottom of the cutting deck is o
ff
set and
facing away from the front of the tractor.
5.
Facing the front of the tractor pull the right corner of the Lane Shark until the
bottom of the cutting deck is facing the tractor once again.
6.
Once the Lane Shark has been completely extended, pull the keeper pin from
the position adjustment pin, and lock it into the desired position hole.
7.
On the backside of the mounting plate the position adjustment pin will
protrude roughly 1/2”. Place the keeper pin that you previously removed
through the exposed hole of the position adjustment pin.
8.
Remove the keeper pin from the kickstand.
9.
Pivot the Lane Shark until the deck is perpendicular with the mounting plate.
10.
Reattach the kickstand to the top mounting bracket and lock it in with the
keeper pin you previously removed.
11.
Reinstall both hydraulic Lines on the Lane Shark.
Figure 1
