L&W SC-180 ES, Руководство по эксплуатации

Страница: 55 / 87

Seite A - 53
A
LW SC-180 ES / LW SC-250 ES
Version: 09.12.2022
M A I N T E N A N C E A N D S E R V I C E
Check or change filter inlet
To properly change the filter inlet, proceed as follows:
• Disconnect the crankcase housing at the ventilation hose (Fig. 1).
• Remove mounting screw and pull out filter housing carefully (Fig. 2).
• Clean filter housing and o-rings and check if defective (fissures).
• Place o-ring into the housing (Fig. 3).
• Insert the new cartridge and assemble the housing. Place o-ring into the groove (Fig. 4).
• Place and align the filter housing carefully, inlet port up, hose connector 90° turned to the left
(Fig. 5).
• Tighten mounting screw and connect the crankcase housing ventilation hose to the oil fill port
(Fig. 6).
The filter inlet change is now completed.
Fig. 1 - Pull off ventilation hose at
the oil fill port Fig. 2 - Pull out filter housing
carefully Fig. 3 - Place o-ring into the filter
housing
Fig. 4 - Place o-ring into the groove Fig. 5 - Place and align filter housing
carefully Fig. 6 - Connect ventilation hose at
the oil fill port
Note
Clean all parts thoroughly before assembly.
i