page 2
P 800.521.2546 F 269.381.3455 www.landscapeforms.com
1. Remove the lid to the Power Unit.
2. Raise power unit to the roof and
space the power unit about 2-1/2”
back from the front edge of the
canopy panel. The wire slots in the
power unit should be toward the
back of the canopy.
3. Mark the location and drill and tap
(4) 5/16-18 holes to secure the
power module to the canopy and
(4) more for the solar panel.
Note: At this point, the solar panel
and the power unit should be
mounted to the shelter roof.
5. Mount Luminaire to interior of
shelter by centering on roof arc
(see installation positions - page
8). Drill and tap ¼-20 hole in shel-
ter using luminaire base to locate
holes. Fix luminaires to shelter
using supplied ¼-20 screws.
Luminaires should be positioned to
direct light straight toward ground.
Pull wire harness from luminaire
module back to power module.
Route wire using interior cavity of
shelter roof arcs.
7. The wiring harnesses from the
luminaires will enter the power unit
through the wire hole.
System Components Overview:
Kaleidoscope® smart shelter installation and maintenance manual
Installation
