Landoll WEATHERPROOFER II 2320 Series, Руководство оператора

Страница: 50 / 59

4-1 TRACTOR PREPARATION
The Landoll 2320 Series Weatherproofer II is
designed to be pulled by tractor equipped with a
double lip or clevis type hitch. If your tractor is not
equipped as such, you need to purchase the hitch
from your local tractor dealer. If your Weather-
proofer II is equipped with the clevis option, this
should be removed. The clevis option is only for
transport use. Before attaching the Weatherproofer
II, prepare the tractor as follows:
4-1.1 Inflate the rear tractor tires equally and
add ballast according to the tractor opera-
tor’s manual.
4-1.2 Lock the tractor drawbar in the center
position.
4-2 WEATHERPROOFER PREPARATION
4-2.1 Prior to operating the 2320 Series
Weatherproofer II, inspect it thoroughly for
good operating condition.
4-2.2 Replace worn or missing parts.
4-2.3 When the machine is new, check the
bolt tightness after a few hours of operation.
Tighten any loose nuts or bolts. Check the
gauge wheel lug bolts daily.
4-2.4 Check the gauge wheel tire inflation. In-
flate all tires equally to avoid side draft. Fol-
low the tire manufacturer’s recommended
pressures listed on the sidewall of the tires.
4-2.5 Check disc scrapers for proper clear-
ance to the disc blade. See Figure 4-1.
a. Loosen U-bolts. Slide scraper assembly to
adjust clearance to 1/8" to 1/4".
IMPORTANT
UNDER CERTAIN CONDITIONS, IT MAY BE
BENEFICIAL TO SET SCRAPERS AS MUCH AS
1" AWAY FROM THE DISCS.
4-2.6 Lubricate the machine as shown in Sec-
tion 4-6 (See Figure 4-4) .
4-3 ATTACHING TO THE TRACTOR
4-3.1 Align the tractor drawbar with the ma-
chine. Raise or lower the Weatherproofer
ring hitch, as needed, using the swivel jack.
Attach the unit with proper size hitch pin.
4-3.2 Clean all hydraulic couplings and attach
to the tractor. When properly attached, the
hydraulic control lever should cause the
Weatherproofer to:
a. Lower to the ground when the control arm is
moved forward or downward, and
b. Raise when the control arm is moved back-
ward or upward.
4-3.3 Fully extend the hydraulic gauge wheel
cylinders, and place the cylinder lockouts in
the transport lock position over the cylinder
rods. Secure the lockouts with the lockout
pins.
4-3.4 Always place the swivel jack on the in-
terior mount before setting the machine in
motion.
4-2
Figure 4-1 Disc Scraper Clearance to Disc Blade