Landoll WEATHERPROOFER II 2320 Series, Руководство оператора

Страница: 25 / 59

3 ASSEMBLY INSTRUCTIONS
It is very important that your new 2320 Series
Weatherproofer II be properly assembled, adjusted
and lubricated before use. Illustrations to assist with
the assembly process are provided in Section 2,
“Standard Specifications” . They show proper
shank, disc gang and mounting bracket spacings. Il-
lustrations in this section show proper assembly
procedures. Remove paint from grease fittings. Re-
place any grease fittings that are damaged or miss-
ing. Be sure to return bolts, clips, etc., to their origi-
nal locations.
To insure alignment of assemblies, leave the
nuts loose until completion of final assembly. Use
lock washers or flatwashers as specified. Spread all
cotter pins.
After completion of final assembly, tighten all
nuts evenly to prevent misalignment, distortion or
binding. Tighten all bolts and nuts to the recom-
mended torques shown in Table 2-1, “Standard
Bolt Torques” .
DANGER
DISC BLADES ARE EXTREMELY
SHARP. EXERCISE EXTREME CARE
WHEN WORKING ON OR NEAR DISC
BLADES. DO NOT ALLOW DISCS TO
ROLL OVER OR FALL ONTO ANY
BODILY PART. DO NOT ALLOW
WRENCHES TO SLIP WHEN WORK-
ING NEAR DISC BLADES. NEVER
PUSH WRENCHES TOWARD DISC
BLADES. DO NOT CLIMB OVER MA-
CHINE ABOVE DISC BLADES. FAIL-
URE TO STAY CLEAR OF DISC
BLADE EDGES CAN CAUSE SERI-
OUS PERSONAL INJURY OR DEATH.
CAUTION
INCORRECT ADJUSTMENT OF DISC
ADJUST RODS WILL CAUSE PERMA-
NENT EQUIPMENT DAMAGE.
WARNING
DO NOT ATTEMPT TO LIFT HEAVY
PARTS (SUCH AS THE FRAME, DISC
GANGS, ROCK SHAFT, AND PULL
HITCH) MANUALLY. USE A HOIST OR
A FORK LIFT TO MOVE THESE
PARTS INTO POSITION.
DANGER
TO PREVENT ACCIDENTAL LOWER-
ING:
1. ALL HYDRAULICALLY ELEVATED
EQUIPMENT MUST BE LOCKED OUT
USING THE CYLINDER LOCKOUTS:
2. LOWER EQUIPMENT TO THE
GROUND WHILE SERVICING OR
WHEN IT IS IDLE.
FAILURE TO TAKE MEASURES TO
PREVENT ACCIDENTAL LOWERING
MAY RESULT IN SERIOUS PER-
SONAL INJURY OR DEATH.
CAUTION
BE SURE DEPTH STOPS ARE EQUAL
LENGTHS ON ALL CYLINDERS. US-
ING UNEQUAL DEPTH STOP
LENGTHS CAN CAUSE PERMANENT
EQUIPMENT DAMAGE.
CAUTION
BE SURE TO BLEED THE HYDRAU-
LIC SYSTEM OF ALL AIR IN LINES
AFTER INSTALLATION. FAILURE TO
BLEED THE SYSTEM OF ALL AIR
CAN RESULT IN IMPROPER MA-
CHINE OPERATION.
3-1