Landoll Weatherproofer I 2410, Руководство оператора

Страница: 41 / 74

ASSEMBLY INSTRUCTIONS
3-23
LED Light and SMV Bracket
Installation (2410-6-24 and
2410-9-24) (After August, 2013)
NOTES
• See Figures 2-1 thru 2-3 for light bracket placement.
If no dimension is given for a bracket, it should be
located against frame member as shown in drawing.
• See Figure 3-15 for Light and SMV Bracket
Installation for 2410-6-24 and 2410-9-24 models.
IMPORTANT
Make sure lights are positioned for maximum
visibility from the rear.
1. Attach left and right light brackets w/ reflectors to
frame using 1/2-13 x 9-1/2 hex head cap screws and
hex lock nuts.
2. Attach ag amber LED single lamps to light brackets
using 1/4-20 x 1-1/4 hex head cap screws and hex
lock nuts
(See Figure 3-15.)
3. Attach left tail light mount to frame assembly using
u-bolts and 5/8-11 hex lock nuts.
4. Attach ag flasher control module to right tail lit mount
using 1/4-20 x 1-1/2 hex head cap screws and hex
lock nuts. Be sure that the control module is set so
that the 4 pin connector faces the right side of the
machine.
5. Attach right tail light mount w/ ag flasher control
module to frame assembly using u-bolt and 5/8-11
hex lock nuts.
6. Attach the ag red single LED lamps and reflector
assemblies to tail light mounts using 1/4-20 x 1-1/4
hex head cap screws and hex lock nuts.
7. Attach front warning harness to frame. Connect 4 pin
end (A) to the two 34” extension harnesses (B and
C), and the ag flasher control module (C)
(See
Figure 3-15.)
NOTE
Figure 3-15 is labeled with letters assigned for each
harness connection to assist in proper lighting intentions.
8. Install the rear warning light harness to the frame.
9. Connect 6 pin end of the ag flasher control module
(D) to the rear warning light harness (D).
10. Connect 2 pin ends of rear warning light harness to
outer amber lights (E).
11. Connect 3 pin ends of the rear warning light harness
(F) to each of the red tail lights. See Figure 3-14 for
LED harness wire designations.
12. Insure that the harnesses are clear of any moving
parts and secure the harnesses with tie wraps
provided.
13. Install the stor-away holder to hose holder on hitch
with 1/4-20 x 3/4 hex head cap screws and hex lock
nuts.
14. Attach SMV emblem and mounting bracket to rear
center frame bar using 1/2-13 x 5-1/2 hex head cap
screws, 1/4 -20 x 3/4 hex head cap screws, and hex
lock nuts. The SMV sign should be centered on the
rear bar of the frame.