Landoll Tilloll 877, Руководство оператора

Страница: 74 / 94

4-2 F-1072-0320
OPERATION AND MAINTENANCE
Tractor Preparation
The Landoll 877 Tilloll is designed to be pulled by tractor
equipped with a double lip or clevis type hitch. If your
tractor is not equipped as such, you need to purchase the
hitch from your local tractor dealer. If your Tilloll is
equipped with the clevis option, this should be removed.
The clevis option is only for transport use. Before
attaching the Tilloll, prepare the tractor as follows:
1. Inflate the rear tractor tires equally and add ballast
according to the tractor operator’s manual.
2. Lock the tractor drawbar in the center position.
3. Install front end weights as needed on the tractor to
maintain stability.
Tilloll Preparation
1. Prior to operating the 877 Tilloll, inspect it thoroughly
for good operating condition.
2. Replace worn or missing parts.
3. When the machine is new, check the bolt tightness
after a few hours of operation. Tighten any loose nuts
or bolts. Check the lift wheel lug bolts daily.
4. Check the lift wheel tire inflation. Inflate all tires
equally to avoid side draft. Follow the tire
manufacturer’s recommended pressures listed on the
sidewall of the tires.
5. Check disc scrapers for proper adjustment to the disc
blade
See Figure 4-1 .The scraper should be 1/8”
from disc blade. To adjust the reversible scraper
loosen the 1/2 flange nut and slide scraper arm until
the 1/8” clearance is obtained. Repeat same
procedure for the LH or RH dual scraper by
loosening the 1/2 lock nut. Re-tighten all nuts. The
scraper blades are reversible to allow extended use
before replacement is required.
6. Lubricate the machine as shown in “Lubrication
Maintenance” on page 4-14 and “Lubrication
Schedule” on page 4-15 .
Figure 4-1: Disc Scraper Adjustment to Disc Blade
Attaching to the Tractor
1. Align the tractor drawbar with the machine. Raise or
lower the disc ring hitch, as needed, using the swivel
jack. Attach the unit with proper size hitch pin.
2. Always place the swivel jack on the interior mount
before setting the machine in motion.
3. Clean all hydraulic couplings and attach to the
tractor.
4. Attach safety chain to tractor allowing plenty of
movement for turning both directions. The safety
chain should latch securely to prevent it coming
loose.
5. Plug in the 7-pin connector for the lights.
a. The tractor should have a good clean receptacle,
free of dirt and corrosion.
b. Make sure the 7-pin connector is inserted all the
way in, and allows the cover to latch over the
keyway to secure it in place.
NOTE
The lighting system requires a good ground
connection and if the lights do not seem to work
check the installation of the 7-pin connector and the
condition of the pins.
1/8”
1/2 FLANGE
LOCK NUT
1/2
LOCK NUT
REVERSIBLE
SCRAPER
LH & RH
DUAL SCRAPER