Landoll Tilloll 877, Руководство оператора

Страница: 36 / 94

3-2 F-1072-0320
ASSEMBLY INSTRUCTIONS
Frame and Hitch Assembly
IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.
Bolt the LH and RH center frame halves together using
5/8”x 2” bolt and 5/8 locknuts.
1. Place the center frame assembly on stands
approximately 36” high. The assembly area should
be a large level area of sufficient size to
accommodate the Tilloll when fully assembled.

WARNING
2. Attach the rear of the hitch assembly to the front of
the center frame using 1-7/16 x 7 pins, machine
bushings, and 1/4 x 2 hex bolts and 1/4 locknuts.
3. Install the tongue jack in the forward mounting tube
and rotate to parking position to support the front of
the hitch.
4. Install mast leveler onto main frame using coulter
support bars, 5/8-11 x 6 hex bolts and 5/8 locknuts.
5. Adjust the radius rod assembly to approximately
71-3/4 hole centers. Visible threads at the top and
bottom of the radius rod should be nearly equal.
Fasten the radius rod assembly to the front hole
using 1-1/4 x 6-1/2 pin and cotter pins. Fasten the top
to the leveler mast using 1-1/4 x 5-5/8 pin and cotter
pins.
6. Insert a 3/4-10 x 7 hex head cap screw into the hose
holder tube on the left side of the hitch from the
bottom side so the threads point upward. Hold in
place with a 3/4 prevailing torque flange nut with the
flange pointing upward as well. Do not tighten this
cap screw, so the hose holder bracket may pivot
freely in this joint.
7. Slide the hose holder bracket over the screw and
secure with another 3/4 prevailing torque flange nut.
8. Install a 3/8-16 x 3-1/2 all-thread screw in the front of
the hose holder bracket and secure with a 3/8-16 hex
nut. Insert the bolt from the bottom so the threads
point upward.
9. Slide the hose holder clamp over the 3/8” screw and
loosely start the wing nut on top of the clamp.
Hydraulic hoses will be routed through the clamp
after assembly.
NOTE
The clamp has two sides, so that extend hoses can
be located on one side and retract hoses can be
located on the other side for reference.
Center Frame Tire Installation
1. Install any hub and spindle assemblies into the main
lift assembly that may have been removed for
shipping. Use 7/16 x 4 bolts and locknuts for 2-1/4
spindles and 1/2 x 4-1/2 bolts and locknuts for 3
spindles.
2. Install the tire/wheel assemblies with 5/8 lug nuts on
the wing frames. 320/70R15 on all sizes.
3. Remove the transport locks from the storage position
and install over the master lift cylinder rods. Install
the lock pins to secure the transport locks in place.
A
Do not attempt to lift heavy parts (such as the
frame, rock shaft, and pull hitch) manually. Use a
hoist or a fork lift to move these parts into
position.