Landoll Brillion SSB, Руководство оператора

Страница: 81 / 102

OPERATION
1P480rev0718 3-19
If the display shows “ Ent ”: You must enter your
password using the UP and DOWN buttons. When your
password is displayed, press the
*
/FUNC button to test
the password. If the password is correct, you will be able
to change the acre counter settings. The password will
be viewable until the acre counter powers down. When
the acre counter is powered up again, you will have to
re-enter the password to change settings.
If the password is not correct, you will not be able to
change the acre counter settings. When the “
PASS ”
function is selected again, “ Ent ” will appear in the
display.
Changing the Password
Select a new password using the UP and DOWN
buttons. Press the
*
/FUNC button until the word “ SEt ”
appears in the display. Release the
*
/FUNC button. The
number in the display is your new pass code. Make sure
you record this number. Press and hold the
*
/FUNC
button until the word “ dIS ” appears in the display.
If the password is forgotten, it can be disabled by
removing the batteries. The password is intended for
rental units. It is recommended that a seal be affixed to
the rear plate of the acre counter to determine if the
settings have been tampered with.
Quick-start Settings for Acre
Meters Prior to 05/15/2012
Settings for Loup Acre Meters
• When the meter is set to “count” mode in pulses screen,
meter will register only magnetic wheel revolutions.
• The meter must be in sleep mode (blank screen) to
calculate acres or to count pulses.
• The count screen must have a value other than zero
(0000) to scroll to other modes or screens.
• To reset the FIELD ACRES screen to zero (0000),
press the up and down buttons simultaneously.
To Program Meter
1. Press the function button to scroll to pulses screen.
2. Enter the number of pulses using the up or down
buttons for the model listed in the chart. See
Table 3-6 .
3. Press the function button to set the pulses. (If screen
goes blank before you press the function button,
repeat steps 1 and 2).
4. Press the function button to scroll to the width
screen.
5. Enter the width of seeder using the up or down
buttons for the model listed in the chart. See
Table 3-6 .
6. Press the function button to set the width. (If screen
goes blank before you press the function button,
repeat steps 4 and 5).
7. Press the function to scroll through the screens to
check that the correct pulses and width have been
entered.
To Enter Password
1. Press the function button to scroll to password
screen.
2. Pick a numeric password and enter it by using the up
or down buttons, until your password is displayed.
3. Press the function button to set password; screen will
show “(set)”. Record number - it is required if you
decide to disable password.
4. Let screen go blank - password is now entered.
5. Press the function button to scroll to the password
screen it will show “ Ent ”. If the screen does not show
“ Ent ”, repeat steps 2, 3 and 4.
To Disable Password
1. Press the function button to scroll to the password
screen it will show “ Ent ”.
2. Use up or down button to enter password (number).
3. Press the function button to scroll around to pass
screen again. Number entered in step 2 will appear.
4. Press up or down button to enter 0.
5. Press the function button; (dis) will appear. Password
is now disabled.