Landoll Brillion Alfalfa SS108, Руководство оператора

Страница: 59 / 92

OPERATION
9K713-0522 3-9
TABLE OF CONTENTS
Seed Box Seed Rate
Adjustment
WARNING
NOTE
To avoid Seed Meter damage, if there is seed in the
Meters, decrease rate in small increments. Decrease rate
no more than one nut revolution and rotate Seed Shaft to
purge seed from Meters. Continue adjustment as
needed.
NOTE
Before filling with seed be sure Seed Shaft turns freely
and Seed Meters are free of any foreign matter.
Wrenches for adjustment are stored on a Pin at the back
of the Transmission.
See Figure 3-10.
Figure 3-10: Adjustment Wrenches
IMPORTANT
If equipped, the Clutch must be disengaged when
Seed Shafts are turned manually for Calibration.
Seed Rate Charts specific to Seeder Model are located
inside the Seed Box Cover and in
this manual. See
Tables 3-1, 3-2 and 3-3 . It should be used as a general
guide only. Based upon your Seeder Model.
Because of seed variation, a more accurate rate can be
determined by turning the 15/16" Hex Nut on the
Transmission to calibrate the Seeder.
(See “Calibration
for Unlisted Seeds” on page 3-11.)
On the right side, the Seed Rate for the Seed Meters can
be set by adjusting the Seed Rate Adjusting Nut and
Adjusting Screw.
See Figure 3-11.
IMPORTANT
Do Not Loosen or Adjust the 1/2-13 Locknut. See
Figure 3-11.
Figure 3-11: Seed Box Seed Rate Adjustment
1. To increase the rate of seeding: loosen the 1-8 Nut
on inside of the Bearing and turn the outer Seed Rate
Adjusting Nut to the desired higher number setting,
then tighten the 1-8 Nut using supplied wrenches.
2. To decrease the rate of seeding: loosen the Seed
Rate Adjusting Nut and set it to the new desired
position; then tighten the 1-8 Nut using supplied
wrenches.
Seed Meters discharge to the front of the machine to aid
the operator in determining proper operation. In addition,
reflective amber decals are placed on the seed shaft to
indicate rotation.
• To prevent damage to seed meters, do not
apply excessive force to adjusting nuts.
Failure to do so may result in the seed being
pinched between the cut-off and washer
inside the seed cup.
• Do not close the meters more than 1/8" when
there is seed in the meters without rotating
the seed shaft to prevent damage to the
rotating washers and retainer rings in the
seed meters.
• Do not attempt to open the meters more than
1". (Feed rolls could become disengaged
from washer in the seed cup.)
Adjustment
Wrenches
Bearing
DO NOT
Loosen or Adjust
1/2-13 Locknut
1-8 Nut
Seed Rate
Adjusting Nut
Adjusting
Screw
Seed Shaft
DO NOT
Loosen or Adjust
1/2-13 Locknut
Op SeedRateAdj 8-10-12