Landoll Brillion Alfalfa SS108, Руководство оператора

Страница: 46 / 92

2-30 9K713-0522
ASSEMBLY
TABLE OF CONTENTS
S-Tine Tire Track Remover
Kit - Optional
IMPORTANT
S-Tines should not be operated any deeper than
necessary to remove Tractor Tire Tracks. Otherwise,
wet soil is brought up and will stick to the Front Roller
Wheels, the S-Tine draft load is increased, and under
some conditions, the S-Tines may deflect back to
Front Roller and break.
NOTE
This S-Tine Tire Track Remover Kit is furnished with 6
S-Tines. Additional S-Tines can be purchased and
installed or fewer S-Tines can be used.
1. Assemble the S-Tine Brackets to the front of Seeder
Frame Tube with 1/2-13 x 7-1/2 x 4-1/2 U-Bolts, Lock
Washers and Nuts. Do Not tighten at this time. Note
that long ends of brackets are downward. Brackets
should be about 53" from center of machine.
See
Figure 2-39.
2. Attach the Tooth Tube to the S-Tine Brackets
approximately 5 inches from each end of the Tooth
Tube with Straps, 1/2-13 x 6 Bolts, Lock Washers and
Nuts.
See Figure 2-39.
3. Center Tooth Tube in relationship with the Drawbar or
3-PT Hitch and Tighten U-Bolts.
4. Attach the S-Tines onto the Tooth Tube in the desired
position to cover the Tractor Tire Tracks with Clamps,
7/16-14 x 3-1/2 Carriage Bolts and Locknuts.
5. The suggested pattern is to assemble the Reversible
Point onto the center S-Tine and a Duck Foot Point on
the S-Tine on either side of the center S-Tine with
3/8-16 x 1-3/4 Plow Bolt and Flanged Locknut.
Figure 2-38: S-Tine Setup
Tractor Tire Depression
Tooth Tube
Bracket
Assembly
S-Tine
Clamp
Carriage Bolt
2 1/2 Point
1 3/8 Point
SUGGESTED SETTING