Landoll 9650, Руководство оператора

Страница: 150 / 182

3-44 F-605-1022
TABLE OF CONTENTS
3 Row Spike and Reel Harrow
Installation
See Figure 2-54 - 2-67 for 3 Row Spike and Reel Harrow
or See Figure 2-68 - 2-81 3RSD & flat reel for placement
dimensions in “Standard Specification” section.
1. Attach the 3 RSD w/spring and 3 RSD w/o spring
arm assemblies to the rear tube of the center and
wing frames using harrow mounting plates, 3/4 x
5-1/2 bolts, clamp bushings and 3/4 lock hex nut
See
Figure 3-33 .
2. Harrow arms 3 RSD w/o spring are used on the
middle harrow arm on the wings.
NOTE
Location of harrow bar mount with tabs, and position
harrow arm assemblies in the correct locations.
3. Refer to Note: spike bar alignment See Figure 3-33
for proper alignment of spike bar assemblies. Be sure
they are aligned properly on both right and left side of
each section.
4. Attach spike bars to 3 RSD spike harrow arm
assemblies per placement drawings using harrow bar
mounts, bar clamp plates 1/2 x 3 bolts, or harrow bar
mounts w/ tabs, 1/2 x 1-1/4 bolts, and hex lock nuts.
5. See spring assembly adjustment for initial setting in
“Operating Section”.
6. Attach reel assembly or flat reel assembly to 3 RSD
arm assemblies using 5/8 u-bolts and 5/8 hex lock
nuts.
7. Install round bar cheveron reels with cheveron
direction matching typical tractor tire direction.
8. Attach flat bar reels with angled blades as shown
See Figure 3-32 .
Figure 3-32: Flat Reel
9. See Figure 2-54 - 2-67 for 3 Row Spike and Reel
Harrow or See Figure 2-68 - 2-81 3RSD & flat reel
placement dimensions of spike harrow arms, spike
bars, and usage of bar clamps or bar clamps w/ tabs.
10. Refer to “3 Row Spike and Reel Adjustments” on
page 4-18 in “Operation and Maintenance” section
for spike angle and spring adjustments.
FRONT