Landoll 900D Series, Руководство оператора

Страница: 36 / 82

3-24 F-823-0216 Edition
OPERATING INSTRUCTIONS
Remote Control (Option)
1. A wireless six function radio remote control is
available
(See Figure 3-13.)
2. The wireless radio remote has six momentary push
button switches that operate the functions as labeled
on the hand held remote.
The wireless radio remote has specifications listed in
Table 3-9.
Figure 3-13: Remote Control Transmitter
Table 3-9: Remote Specifications
3. TO OPERATE THE REMOTE:
a. Press and hold the POWER button for at least 2
seconds and release.
b. The transmitter is designed with a power saving
feature which turns the transmitter off after 15
minutes if no buttons are pressed.
c. There are red and green LED’s both on the
keypad of the transmitter and inside the receiver
case. The green LED will blink 2 times per
second when the transmitter and receiver are
communicating. It will blink 1 time per second if
there is no communication (i.e. - no power to the
receiver).
d. The red LED on the transmitter and in the
receiver will blink if there is a shorted or open
output. Refer to
Table 3-10 and Table 3-11 and
count the number of blinks to determine the
output with the fault.
e. The transmitter’s red LED blinks 1 time per
second if the batteries are low and need to be
replaced. To confirm a low battery condition, turn
the receiver off and leave the transmitter on. If
the transmitter red LED continues to blink, the
battery is low and requires replacement. If the
red LED blinks only when the receiver is on,
there is a fault with one or more outputs, as
stated above.
f. The red LED will stay on while charging and
when the charge is completed the green LED will
stay on.
g. It will take longer to charge if the transmitter is on
during charging.
Table 3-10: Transmitter Error Code Chart
REMOTE SPECIFICATIONS
RF 902-928 MHz FHSS 10mW
TEMPERATURE -
RECEIVER
- 40° to 85° C
TEMPERATURE -
TRANSMITTER
- 20° to 60° C
OUTPUT RATING
5 AMPS EACH (SOURCING)
20 AMP SYSTEM MAXIMUM
TRANSMITTER IP - 66
POWER 3.7V LiPo BATTERY
BATTERY LIFE
30 - 40 HOURS
CONTINUOUS
TRANSMITTER RED ERROR
CODE LIGHT
GREEN
SIGNAL LIGHT
6-FUNCTION
DECAL
TRANSMITTER ERROR CODE CHART
ERROR CODE PROBABLE CAUSE
1 LOW BATTERY
2 TILT DOWN FAULT
3 TILT UP FAULT
4 WINCH OUT FAULT
5 WINCH IN FAULT
6 AXLE BACK FAULT
7 AXLE AHEAD FAULT
Ea
st
ern
W
re
cke
r Sa
le
s
In
c