Landoll 900C Series, Руководство оператора

Страница: 32 / 80

3-20 F-473-0212 Edition
OPERATING INSTRUCTIONS
Figure 3-11: Hydraulic Engine Package Control Panel (Option)
Hydraulic Power Supply Engine
Operation (Option)
1. The Hydraulic Power Supply Engine system is used
to power the hydraulic functions, should the tractor
not be equipped with hydraulic hookups.
IMPORTANT
1. Check the following fluids before starting the
engine package: engine oil, fuel supply, hydraulic
oil. (Check oil level while semitrailer is not tilted.
If semitrailer is tilted, the oil level in the tank will
not read accurately.)
2. If the engine does not crank, check the following
on the battery: charge fluid, terminals, and
cables. Take corrective actions as needed.

CAUTION
2. The ENGINE IGNITION SWITCH is located below
the hydraulic controls, and behind them on the
driver’s side of the semitrailer. Use the key to start
and stop the Hydraulic Power Supply Engine
(See
Figure 3-11.) This switch has three positions:
LANDING GEAR CONTROL
ENGINE IGNITION SWITCH
ENGINE THROTTLE
ENGINE CHOKE
mem950b-51-ctrl-pn
l
If the hydraulic fluid level is low during operation,
the semitrailer may not operate correctly,
resulting in damage to the semitrailer.
OFF In this position, the power package
engine does not run. The key can only
be inserted or removed from this
position.
RUN In this position, the engine runs without
activating the starter.
START In this position, the starter cranks the
power package engine, to start it. After
the engine is started, release the key to
the RUN position.