Landoll 876 Series, Руководство оператора

Страница: 23 / 58

3-1 FRAME AND WING ASSEMBLY
IMPORTANT
READ ALL SAFETY PRECAUTIONS AT THE
FRONT OF THE SECTION BEFORE ATTEMPT-
ING ANY OF THE FOLLOWING PROCEDURES.
IMPORTANT
SEE FIGURES 3-1 THROUGH 3-3 FOR PART
NAMES.
3-1.1 Bolt frame halves together using 5/8-11
x 2 hex head cap screws and hex lock nuts
(See Figures 3-1 and 3-2).
3-1.2 Attach SMV mounting bracket and warn-
ing light bar to rear of frame near center with
1/2-13 x 5-1/2 hex head cap screws and hex
lock nuts (See Figure 3-1).
3-1.3 Attach SMV emblem to SMV mounting
bracket using 1/4-20 x 1 hex head cap
screws and hex lock nuts.
3-1.4 On 30’ and 35’ models, connect wings
to frame using 1-8 x 7-1/2 hex head cap
screws, 1" flat washers, steel bushings, and
hex lock nuts (See Figures 3-2 and 3-3).
3-1.5 On 40’ model, connect wings to frame
using 1-8 x 8 hex head cap screws in top
hole and 1-8 x 7-1/2 hex head cap screws in
bottom hole of hydraulic wing hinge bar, 1"
flat washers, steel bushings, and hex lock
nuts (See Figures 3-2 and 3-3).
3-1.6 On 40’ models, connect wing frame ex-
tensions to wings using 5/8-11 x 1-1/2 hex
head cap screws and hex lock nuts (See
Figure 3-3).
3-1.7 Place frame and wing assembly on
stands approximately 36" high.
3-1.8 For 30’ models, install short and long
wing supports to wing using u-bolts and
5/8-11 hex lock nuts (See Figures 2-1
through 2-6 for location on frame).
3-1.9 For 35’ models, install wing support
weldments to frame using u-bolts and 5/8-11
hex lock nuts (See Figures 2-1 through 2-6
for location on frame).
3-1.10 For 40’ models, install long wing sup-
ports to frame using u-bolts and hex lock
nuts. Install stands to right hand wing using
5/8-11 x 2 hex head cap screws and hex
lock nuts (See Figures 2-1 through 2-6 for
location on frame).
3-1.11 Install mast assembly to frame using
coulter support bars, 5/8-11 x 6 hex head
cap screws, and hex lock nuts.
WARNING
DO NOT ATTEMPT TO LIFT HEAVY
PARTS (SUCH AS THE FRAME, DISC
GANGS, ROCK SHAFT, AND PULL
HITCH) MANUALLY. USE A HOIST OR
A FORK LIFT TO MOVE THESE PARTS
INTO POSITION.
3-5