Landoll 6250 Disc, Руководство оператора

Страница: 73 / 94

OPERATION AND MAINTENANCE
4-9
3. After adjusting the cylinder rod or rods, the radius rod
needs to be adjusted back to a neutral position. This
is accomplished by fully retracting the lift cylinders
and adjusting the radius rod until there is no load on
it, reinstall the 1” bolt and then tightening the jam
nuts on each end.
NOTE
Center frame cylinders may have 1/8” rod exposed when
fully retracted due to the rephasing system.
4. Leveling the Disc side-to-side involves leveling the
wing frame to the center frame. The unit should be
level side-to-side when operating in the field.
5. To level the unit:
a. Verify that all tires are properly inflated, and that
the center radius rod adjustment has been
properly set.
b. With the implement unfolded, raise the unit to
fully extend the lift cylinders. Continue to hold the
tractor lever 30-60 seconds to insure that the
cylinders are fully extended and the rephasing lift
system has been purged of air.
c. Lower the unit until the disc blades are
approximately 1” off the ground.
d. On the center frame, measure the distance from
the welded tube in the walking beam to the top
side of the frame
(See Figure 4-10.)
e. On the wing frame, measure the distance from
the welded tube in walker to the top side of the
wing frame
(See Figure 4-11.)
f. The wing frames are generally set to the same
distance or slightly higher than the center frame.
The 6250-40 requires adding 1” from the center
frame measurement for the wings due to the
smaller tires on the wing frame. The 6250-45/50
requires adding 3/4” from the center frame
measurement for the wings due to the smaller
tires on the wing frame.
g. Adjusting the anchor at the base end of each
wing lift cylinder sets wing frame height
(See
Figure 4-12.)
6. An adjusting wrench is provided to make this
adjustment. It may be necessary to lower the wing to
the ground and relieve weight on the cylinder anchor
to make this adjustment. If required, fully raise the
implement, lower to just above the ground, and
re-verify measurements. Repeat as necessary and
securely tighten the cylinder anchor when complete.
Figure 4-10: Leveling Center Frame from Side to
Side
Figure 4-11: Leveling Wing from Side to Side
Figure 4-12: Wing Lift Adjustment
NOTE: THIS MEASUREMENT IS 1” MORE
THAN CENTER FRAME FOR 6250-40’,
THIS MEASUREMENT, IS 3/4” MORE
THAN CENTER FRAME MEASURMENT
FOR 6250-45’/50’
MEASURE