Landoll 6250 Disc, Руководство оператора

Страница: 39 / 94

ASSEMBLY INSTRUCTIONS
3-11
Leveler Assembly
1. Attach rear of leveler assembly to the center left lift
using the leveler pins through the leveler base/cross.
NOTE
For normal operation of Disc, use the lower set of cross
holes to mount the leveler assembly to the center left lift.
2. Slip the leveler pin keeper over the leveler pin hole
and slide up into place so that the slots in the leveler
pin sit firmly in the straight sides of the keyhole. This
will be done on both sides of the leveler assembly.
3. Connect the top of the leveler pin keeper to the
second hole from the top of the center lift leveler
mount plate using a 3/4-10 x 2-1/4 hex head cap
screw and hex lock nut.
4. Attach leveler tower to the center frame using a hitch
pin, leveler spacer, 1/2 x 2-1/4 grooved alloy pin, and
1-8 hex lock nut.
NOTE
The leveler spacer is located between frame ears.
5. Attach the top of the leveler tower to the leveler
assembly with hitch pin, 1/2 x 2-1/4 grooved alloy pin,
1-1/2” washers, and 1-8 hex lock nut.
NOTE
For normal operation use the mounting hole on the end
of the leveler tube. Drawbars of 17” or less could require
the 2nd hole in.
6. Attach leveler tower to the top of the leveler ball joint
link with hitch pin, 1/2 x 2-1/4 grooved alloy pin, (2)
1-1/2” washers, and 1-8 hex lock nut.
7. Attach the leveler ball joint link to the lower hole of
the lower hole of the hitch plate with a 1-1/2-6 x 6 hex
head cap screw, split lock washer, and hex nut
(See
Figure 3-9.)
NOTE
When the hitch is in the upper mounting position, the
leveler ball joint link is mounted in the lower holes. When
the hitch is in the lower position, the link is mounted in the
top mounting holes.
See “Hitch Adjustment” on
page 4-11 for proper adjustment.
8. Place 3/16 x 1 spring slotted pins into two holes in
the level indicator rod. Slide the level indicator rod
into the hole in the end of leveler base so that the first
pin is inside the leveler base. Rotate the level
indicator rod so that the pins hold the rod in place.
9. Connect the level indicator gauge to the tube leveler
assembly using 1/2-13 x 6-1/2 hex head cap screw,
leveler spacer, flat washers, and hex lock nut.
10. Place short end of bent rod through level indicator
gauge and hold in place with a hairpin.
11. Install (2) 90 elbows w/ 1/32” restrictors. Note that
only two are supplied with the machine, and they are
red.