Landoll 6230, Руководство оператора

Страница: 33 / 80

3-8 CENTER FRAME TIRES
3-8.1 Install the tire and wheel assemblies on
the center section.
3-9 DISC GANGS
DANGER
D I S C B L A D E S A R E E X T R E M E L Y
SHARP. EXERCISE EXTREME CARE
WHEN WORKING ON OR NEAR DISC
BLADES. DO NOT ALLOW DISCS TO
ROLL OVER OR FALL ONTO ANY
B O D I L Y P A R T . D O N O T A L L O W
WRENCHES TO SLIP WHEN WORKING
NEAR DISC BLADES. NEVER PUSH
WRENCHES TOWARD DISC BLADES.
D O N O T C L I M B O V E R M A C H I N E
ABOVE DISC BLADES. FAILURE TO
STAY CLEAR OF DISC BLADE EDGES
CAN CAUSE SERIOUS PERSONAL IN-
JURY OR DEATH.
3-9.1 Attach the disc gang assemblies to the
center section using 3/4-10 x 2 grade 8 hex
head cap screws and hex lock nuts
(See
Figure 3-8) . Use a 3/4-10 x 2-1/2 grade 8
hex head cap screw, manifold mounting
bracket, and hex lock nut on the center front
screw of the right front gang for all sizes.
3-9.2 21’, 23’, and 29’ models, require a
3/4-10 x 2-1/2 grade 8 hex head cap screw,
manifold mounting bracket, and hex lock nut
at the back hole of the center right rear
gang.
3-9.3 On 30’-36’ models, use 3/4-10 x 2-1/2
grade 8 hex head cap screws at the center
of each left front gang.
3-9.4 Insert plastic flange bearings into each
end of round tube ends of the center and
wing frame disc gang assemblies.
3-9.5 Install a 1/2 x 2-1/4 slotted spring pin in
the end of each hinge pin.
3-9.6 Assemble each wing gang to the center
frame gang using the hinge pin, 1-1/2 thrust
washer, 1” washers, and 1-8 hex lock nut.
Note: The thrust washer is positioned on the
front side of the hinge on the front gangs,
and on the rear side of the hinge on the rear
gangs.
3-9.7 Place the outer ends of the gang bars
on stands so the wing gangs are level with
the center section.
3-17