Landoll 2430-11-24, Руководство оператора

Страница: 65 / 74

OPERATION AND MAINTENANCE
4-7
Hydraulic Maintenance
1. Check the tractor hydraulic fluid level per tractor
owners manual and after any leakage. Check fluid
level with the cylinders in the retracted position.
2. If a cylinder or valve leaks, disassemble the parts to
determine the cause of the leak. Any time a cylinder
is opened up, or whenever any seal replacement is
necessary, it is advisable to clean all parts and
replace all seals. Seal kits are available from your
Landoll dealer.
3. Check all hydraulic hoses weekly. Look for binding or
cracking. Replace all worn or defective parts
immediately.
IMPORTANT
Lower the unit to the ground, and relieve hydraulic
pressure before attempting to service any hydraulic
component.
4. Transport locks are provided to hold the implement in
a raised position. Do not attempt to perform any
service work under the implement without first
installing the transport locks. Before servicing any
hydraulic component, lower the implement to the
ground and relieve all system pressure. If a hydraulic
component is disconnected, repaired, or replaced, it
will be necessary to purge the system of air before
operation.
See “Hydraulic Lift System” on
page 4-3 on how to purge the hydraulic systems.
Figure 4-9: Hitch and Safety Chain
Transport
1. Check and follow all federal, state, and local
requirements before transporting the Weatherproofer
I.
2. The Weatherproofer I should be transported only by
a tractor required for field operation. The implement
weight should not exceed more than 1.5 times the
tractor weight. Unless noted on the implement,
maximum transport speed is 20 mph for the
implement. Slow down when driving on rough roads.
Reduce speed when turning, or on curves and
slopes to avoid tipping.
3. A safety chain is provided with the implement to
insure safe transport.
a. The safety chain should have a tensile strength
equal to or greater than the gross weight of the
implement. The chain is attached to the lower
hitch clevis hole with two flat washers between
the clamp plates to assure a tight connection.
Always use a 1” diameter Grade 8 bolt for this
connection.
b. Attach the safety chain to the tractor drawbar
(See Figure 4-9.) Provide only enough slack in
the chain for turning. Do not use an intermediate
chain support as the attaching point for the chain
on the tractor. Do not pull the implement by the
safety chain.
c. When unhitching from the tractor attach the hook
end of the chain to a free link close to the hitch
clevis for storage. This will keep the hook off the
ground, reducing corrosion and keep the hook
functioning properly.
d. Regularly inspect the safety chain for worn,
stretched, or broken links and ends. Replace the
safety chain if it is damaged or deformed in any
way.
HITCH
WELDMENT
SPEED
IDENTIFICATION SYMBOL
SAFETY
CHAIN
2410 safety chain