Landoll 2210, Руководство оператора

Страница: 29 / 52

3-3 2215 ROCKSHAFT INSTALLATION
IMPORTANT
READ ALL SAFETY PRECAUTIONS AT THE
FRONT OF THE SECTION BEFORE ATTEMPT-
ING ANY OF THE FOLLOWING PROCEDURES.
IMPORTANT
SEE FIGURE 3-2 and 3-3 FOR PART NAMES.
3-3.1 Position the rockshaft under the gauge
wheel mounting brackets.
IMPORTANT
THE GAUGE WHEEL ARMS SHOULD POINT TO
THE REAR OF THE MACHINE WITH THE CYLIN-
DER ANCHORS FACING UP.
3-3.2 Install the upper bearings.
a. Slip the 3/4" X 8-1/2" cap screws through
the holes provided for them in the mounting
brackets.
b. Place the upper bearing halves (with the
grease zerk in the side) on top of the rock-
shaft. There are five bearing assemblies on
the rockshaft.
IMPORTANT
BE SURE TO INSTALL THE FIFTH BEARING IN
THE CENTER, TO ITS PROPER MOUNTING
BRACKET.
c. Use a hoist or forklift to raise the rockshaft.
Use the cap screws to guide the rockshaft
and top bearing halves into place.
3-3.3 Set a lower bearing half (with a grease
zerk between the bolt holes) under the rock-
shaft and through the hanging ends of the
cap screws.
3-3.4 Secure each set of bearings tight enough
to the rockshaft to hold the assembly to-
gether. Use the washers and locking nuts
provided.
3-3.5 Insert the rockshaft shims, as needed, be-
tween each set of bearings. Use the shims
to allow the rockshaft to rotate freely, yet not
loosely, in the bearing halves. Repeat this
step for each set of bearings. Then tighten
the cap screws.
3-3.6 Mount the tires on the wheel rims and as-
semble to the hubs. Tighten wheel bolts
evenly to assure proper wheel alignment.
Wheel bolts should be tightened to 90 ft-lbs
of torque. The hoist can then be removed.
IMPORTANT
AN 11L X 15" FARM SERVICE TIRE SHOULD
BE USED ON THE 15" X 8" RIM. INFLATE THE
TIRE TO ITS MANUFACTURER’S RECOM-
MENDED PRESSURE.
3-3.7 Install the base end of the gauge wheel
cylinders on the frame cylinder anchors.
Face the rod end down, towards the gauge
wheel, and face the ports upwards (See Fig-
ure 3-3) . Secure each cylinder to the cylin-
der anchor with the clevis pins and cotter
pins supplied with the cylinder.
3-3.8 Position the lockout assemblies above the
gauge wheel arms and the rod ends of the
cylinders (See Figures 3-2 and 3-3) . The
open end of the lockouts should be over the
gauge wheel arms with the U-shaped cutout
on the opposite end facing upwards.
3-3.9 Insert the extended cylinder pin through
the lockout assembly, the cylinder clevis and
the gauge wheel arm bracket (See Figure
3-3) . Secure with hairpin clips.
3-5