Landmann Pellet Kettle, Инструкция по установке и эксплуатации

Страница: 15 / 28

Pellet Kettle
15
CONTROL PANEL INTRODUCTION
STARTUP CYCLE
When the power button is pressed on and the dial is turned to any setting, the startup cycle is initiated.
START will show in the display during the startup cycle. The auger and the fan will run continuously. The
ignitor rod will power on for 5 minutes to ignite the pellets in the fire pot. After 5 minutes, the ignitor rod
turns off.
RUN CYCLE
The auger and fan will always run depending on the temperature selected on the control panel. The fan and
auger speed will vary depending on the temperature setting selected.
STANDBY CYCLE
When the control dial is turned to STANDBY, STANBY will display. This shuts down the auger and fuel
supply but the fan continues to run for up to 8 minutes burning off any remaining fuel in the fire pot. This is
a very important step in using your grill.
POWER SWITCH
Turns the power to the grill on or off.
6 DIGIT LED DISPLAY
Monitors current grill functions and status of the grill. Dual
temperature monitor of setting and current temperatures.
11 SETTING CONTROL DIAL
Controls the grill temperature setting, rotate to setting desired.When
the dial is turned to OFF, the shutdown mode begins. The fan will run
for 8 minutes to burn off any remaining pellets in the fire pot.
FEED
Activate the auger by pressing and holding the FEED button for 3
seconds. Use this function to fill the auger with pellets for the first
time the grill is used or anytime the grill runs out of pellets. The auger
will run for 5 minutes.
BYPASS
If there is a power failure to the grill during use, press and hold
the BYPASS button for 3 seconds to bypass the normal startup
mode of the grill when the power is returned. This applies only if the
power was cut for only a short time. If the grill fails to ignite using
the BYPASS mode, the grill will need to be restarted in the normal
startup mode. The BYPASS button can also be used to cancel the
FEED mode.
PROBE TEMP
When the meat probe is used, press button to have the food
temperature displayed on the control panel. Press a second time to
have the probe and grill temperatures toggle back and forth.
PROBE
Insert the plug end of the cord into control panel and the metal
probe into the food to get the food temperature on the display.
Pellet Kettle
PROBE
TEMP
FEED
BYPASS
PROBE
POWER
150 ºC
135 ºC
120 ºC
105 ºC
SMOKE HIGH
230 ºC
205 ºC
190 ºC
175 ºC
ST
A
N
D
BY
FUCTIONS