Landmann Miton PTS 3.1, Сборка и руководство по эксплуатации

Страница: 13 / 28

13
Miton PTS 3.1
Troubleshooting
If there is a fault despite due care, this chapter may help you to resolve the fault.
Fault Possible cause Remedy
There is a smell of gas Leak in the gas system 1. Close the cylinder valve imme-
diately.
2. Prevent any flame or spark for-
mation (do not switch on any
electrical appliances)
3. Tighten all connections on the
gas system
4. Check all components of the
gas system for visible damage;
replace defective parts with ori-
ginal spare parts
5. Check for leaks using a leak
detector
Burner does not ignite Gas cylinder is empty Replace the gas cylinder
Cylinder valve is closed Open the cylinder valve.
The nozzle on the adjusting ele-
ment (behind front panel) is not
inserted into the burner hose.
Visual inspection, if necessary
adjust nozzle and connection hose.
The ignition cable is not in contact
with the electronic pulse ignition
Conduct a visual inspection, con-
nect if necessary
Distance between the spark plug
and gas outlets on the burner is
incorrect
Visual inspection; correct if neces-
sary
Nozzle on adjusting element
(underneath front panel) is
blocked.
Clean the adjuster jet with a need-
le
Other gas system blocked The gas system should be cleaned
by a specialist
Barbecue temperature too low Pre-heating time too short Grill unit coverClose the lid and set
the flame regulator to max
Gas outlets on the burner are
blocked
Remove blockage from burner
Strong flare-up Fatty foods Remove any large areas of fat pri-
or to barbecuing or place the meat
on a grill plate or reduce the bar-
becue temperature
Deflagration or bubbling noise Flashback caused by blockages in
the burner.
1. Close the cylinder valve imme-
diately.
2. Wait 3 minutes and then
switch the barbecue back on
3. If the malfunction reoccurs,
disassemble and clean the bur-
ner