Landmann Miton PTS 3.1, Сборка и руководство по эксплуатации

Страница: 8 / 28

8
Miton PTS 3.1
Assembly
Here are a few tips to help you assemble your barbe-
cue quickly and successfully:
• Check that no parts are missing by placing all of
the individual parts on an empty table (subject to
minor technical changes).
• If, despite careful factory checks, a component
should be missing, please contact our customer
service department (see last page). We will imme-
diately attend to your request.
• To assemble the barbecue, all you need is a medi-
um-sized screwdriver.
• Only use tools that are intact and suitable for the
job at hand. Worn or unsuitable tools will not
allow you to tighten the bolts sufficiently, but will
damage them to the extent that they can no lon-
ger be turned.
• Always fit all connecting elements (screws, nuts,
bolts, et cetera) as shown in the illustrations. If you
misplace a connecting element, replace it with an
appropriate part. Only by doing this can you ensu-
re that the construction is strong and safe.
• Be sure to follow the instructions in the specified
order!
• Even if you are not experienced at DIY, assembly
does not generally take longer than one hour.
•
The illustrations showing the assembly steps are
at the end of this manual.
Connecting and disconnecting
the gas cylinder
Parts and tools needed
• Gas cylinder
Common camping gas cylinder, fill weight 4.5 or
7 kg, (e.g. grey camping propane gas cylinder).
These are available at DIY shops or from liquid gas
suppliers.
Leak indicator
• You can locate any leaks in the gas system using a
leak detector. This can be purchased at DIY shops
or liquid gas suppliers. Please follow the operating
instructions of the leak detector.
The following parts are included in delivery. They
comply with the standards applicable in the country
to which they have been supplied by Landmann.
Gas hose (pre-assembled)
-approved hose of a sufficient length (max. 1.5 m)
to allow for kink-free assembly.
• Pressure regulator (already attached to the gas
hose)
Preset and -approved pressure regulator, max.
1.5 kg/h, operating pressure 28-30/37 mbar, suita-
ble for the gas cylinder used.
Permitted gas cylinder sizes
4.5 kg: Ø 240mm x 340mm
7 kg: Ø 256mm x 495mm
It is recommended that you only use propane gas
with your LANDMANN barbecue which is fitted with
a propane gas regulator!